You can plan a new route with the commands Planning a new route or Planning a round trip.

• A new route with the name “New Route” is created and saved in the active route table.
• The info of this new route opens in a panel docked on the left
• In the map window the 30_edit 22222 Edit Mode with append points is activated.

So you can immediately start to select or click the route points one by one on the map.

With the command Planning a round trip you can plan a new round trip. The Graphhopper routing engine is required for this. You can choose from different profiles, motorbike curved, car, bicycle etc.

• Set the desired, approximate length of the route and
• optionally a direction in which the round trip should start from the start
• Then click on the desired starting point on the map, which is also the end point.
• Now click on Generate to calculate the route:

Now you can vary the parameters length and direction, click Generate each time until the result fits.

Planning a route